Quantcast
Channel: product recall – Suffolktradingstandards's Blog
Viewing all articles
Browse latest Browse all 1393

Recall: Futaba/Ripmax Mains Chargers

$
0
0

The following notice has been issued by the manufacturer:

Product: Futaba/Ripmax Mains Charger
Part number: P-FBC32D/4
Affected batches: All

back front

As part of their market surveillance process, Trading Standards have tested the above charger and found it to be unsafe and pose serious risk of electric shock and fire because of the following factors relating to BS1363-1.

Test results:-

  • The thickness of the live and neutral pins was found to be up to 0.23mm oversize.
  • The breadth of the live and neutral pins was found to be up to 0.12mm oversize
  • The insulated shutter device (ISOD) was found to be 0.03mm over height and 0.01mm over thickness.
  • The disposition of the plug pins was found to require a force in excess of 10N (the maximum) to insert it in a socket and remove it. With a force of 10N it would not fully engage.
  • When inserted in a special measuring gauge, the live and neutral pins were too short.
  • The live and neutral pins were found to be too close to the edge of the periphery of the engagement face by 4.66mm.

As part of the recall process for the P-FBC32D/4 charger, we have been required to identify any similar products that could be at risk. The following two chargers use the same case design as the P-FBC32D/4 and have therefore been deemed to pose a similar serious risk of electric shock and fire because of the following factors relating to BS1363-1. Trading Standards have therefore requested us to make this recall today.

Product: Futaba/Ripmax Mains Charger
Part number: P-FBC30D/4 and F-FBC35D/4
Affected batches: All

FBC30D FBC35D

Conclusion:-
Excessive force was required to insert the charger into, and remove it from, a socket. This could cause damage to the socket and the shutter system and/or cause mechanical damage to the charger that could result in live parts being exposed, with the risk of causing an electric shock.
Could cause overheating or arcing within the socket creating a risk of fire.

Could lead to inadvertent contact with the live parts of the pins when inserting the charger into, or removing from, a socket.

If you have purchased one of these chargers on its own or as a component of a another product, stop using it immediately and please return it as soon as possible to the dealer that you bought it from. Ripmax will arrange to send the dealer a new replacement as soon as they are available from the manufacturer.



Viewing all articles
Browse latest Browse all 1393

Trending Articles